One Shot BLHeli_32 35A 32 bit 2-5S ESC
Available on backorder
- Input: 2-5S input Maximum input 6S (close brake)
- 32bit architecture
- Telemetry capability (voltage, current, temperature, speed)
- All inputs and outputs are protected against overvoltage (~30V) and under voltage (~-30V). 3,3 and 5V capable
- Supports all common Dshot commands like Turtle Mode, 3D mode and change of rotation
- Overcurrent protection (measures the current and reduces it to max. 40A)
₹1,833.00 ₹2,833.00
Available on backorder
This is a One Shot BLHeli_32 35A 32-bit 2-5S ESC.
BLHeli is firmware designed for multi-copter performance that runs on some Atmel and SiLabs ESCs and supports OneShot125. BLHeli Suite is the companion application (Windows only) that allows users to flash and configure BLHeli ESCs (Electronic Speed Controllers).
The 32-bit architecture enables the ESC to run at incredible speeds, resulting in better performance, faster input signals, and lower latency compared to older 8-bit ESCs. These ESCs are low profile and compact, saving weight and making builds easy. OneShot125 is a special mode for ESCs running BLHeli firmware, allowing the supported flight controller to communicate very quickly with the ESC, enabling motors to react much faster than standard PWM communication protocols.
It adopts a 32-bit STM32F051 main control chip, which offers faster response speed and processing capability. The operating frequency of up to 48MHz and high-performance three-in-one drive reduce throttle signal receiving delay, enhancing the response and control of the motor. High speed and precision allow pilots to enjoy the thrill and advantage of flying at speed.
BLHeli was the original open-source software but is no longer maintained and is not available on modern ESCs. BLHeli_32 is closed-source and based on 32-bit ARM MCUs. All modern ESCs use BLHeli_32, which remains open-source firmware.
Packages Includes:
1 x BLHeli_32 35A 32 bit 2-5S ESC
There are no reviews yet.