Programmer
Showing all 14 results
-
-
Development Boards, Programmer
MCP2515 CAN Module TJA1050 Receiver SPI 51 Single Chip Program Routine Arduino
-10%
Development Boards, ProgrammerMCP2515 CAN Module TJA1050 Receiver SPI 51 Single Chip Program Routine Arduino
- Support CAN V2.0B technical standard, communication rate 1Mb / S.
- Module 5V DC power supply, SPI interface protocol control
- 0 to 8 bytes long data field.
- 8MHZ crystal oscillator
- 120Ω terminal resistance
- Use High-speed CAN transceiver TJA1050
- Impedance matching, guaranteed drive capability, long-distance data transmission, prevent signal radiation
- The working current: typical 5mA, standby current 1 microamp. Except for the power indicator.
SKU: n/a -
Development Boards, Programmer
ST Link V2 Programmer For STM8 and STM32
- PCB installed inside of aluminum alloy U disk shell, portable, safe and reliable!
- Interface definition directly marked on the shell, clear, convenient and practical!
- 5V, 3.3V offers at the same time, allowing you to program your target board with both 5V and 3.3V
- Shell characters using laser engraving, never fade off! Permanent clarity!
- 500MA internal resettable fuse, complete protection of your expensive computer motherboard!
- SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector
- SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed
SKU: n/a -
Development Boards, Programmer
ST-LINK/V2 in-circuit debugger/programmer for STM8 and STM32
- 5V power supplied by a USB connector
- USB 2.0 full speed compatible interface
- USB standard A to mini B cable
- 1.65V to 5.5V application voltage supported on SWIM interface
- SWIM low speed and high-speed modes supported
SKU: n/a -
Development Boards, Programmer
PIC K150 USB Automatic Develop Microcontroller Programmer with ICSP Cable (Body width: 10 mm)
-13%
Development Boards, ProgrammerPIC K150 USB Automatic Develop Microcontroller Programmer with ICSP Cable (Body width: 10 mm)
- Support the most popular programming PIC chips, read, encryption and other features!
- No external power supply, communication, and power is only a USB cable to print complete, without any cable.
- PICSTARTPLUS much faster rate than programming.
- Can easily read the contents of the chip program area.
- Automatic programming verification.
- Comprehensive information prompts, allowing users to understand the working state.
SKU: n/a -
Development Boards, Programmer
PIC K150 USB Automatic Develop Microcontroller Programmer with ICSP Cable (Body width: 4 mm)
-10%
Development Boards, ProgrammerPIC K150 USB Automatic Develop Microcontroller Programmer with ICSP Cable (Body width: 4 mm)
- Support the most popular programming PIC chips, read, encryption and other features!
- No external power supply, communication, and power is only a USB cable to print complete, without any cable.
- PICSTARTPLUS much faster rate than programming.
- Can easily read the contents of the chip program area.
- Automatic programming verification.
- Comprehensive information prompts, allowing users to understand the working state.
SKU: n/a -
Development Boards, Programmer
STMICROELECTRONICS Development Board, STM32F410RB Nucleo-64 MCU, ST-LINK/V2-1 Debugger/Programmer, Arduino/ST morpho
-6%
Development Boards, ProgrammerSTMICROELECTRONICS Development Board, STM32F410RB Nucleo-64 MCU, ST-LINK/V2-1 Debugger/Programmer, Arduino/ST morpho
- USB VBUS or external source (3.3V, 5V, 7 to 12V) and power management access point
- USB communication (LD1), user LED (LD2), power LED (LD3)
- Two push buttons – USER and RESET
- USB re-enumeration capability – virtual com port, mass storage, debug port
- Supported by wide choice of IDEs including IAR, Keil, GCC-based IDEs
SKU: n/a -
Development Boards, Programmer
PICkit3 Debugger Programmer Emulator Controller Development Board
- Full-speed USB support using Windows standard drivers
- Real-time execution
- Processors run at maximum speeds
- Built-in over-voltage/short circuit monitor
- Low voltage to 5V (1.8 to the 5V range)
- Read/write program and data memory of the microcontroller
- Program up to 512K byte flash.
SKU: n/a -
Development Boards, Programmer
Altera MAX II EPM240 CPLD Development Board
- Onboard the EPM240T100C5N chip.
- EPROM chip configuration using EPCS4, the size of 8Kbit.
- Onboard 50M active patch crystal (Crystal Slaughter halfback).
- Power supply with a largemouth outlet, single 5V power supply.
- Board has a power indicator and reset switch.
- More IO ports and clock pins through the pin leads through these interfaces can be extended to any memory and peripherals.
SKU: n/a -
Development Boards, Programmer
STM8S 8L TSSOP20 Burning Testing Holder Downloader Offline Programmer
-6%
Development Boards, ProgrammerSTM8S 8L TSSOP20 Burning Testing Holder Downloader Offline Programmer
- The onboard high quality imported gold-plated chip carrier;
- By SWIM interface, directly related to type of chip test, burning;
- Crystals can be free replacement by the user;
- All I / 0 by 2.54 mm double row needle derivation, convenient for the user to build circuit;
- Through the selection of four dial the code switch STM8S or STM8L burning.
SKU: n/a
