ESC-Drone Speed Controller
Showing 1–24 of 67 resultsSorted by popularity
-
-
ESC-Drone Speed Controller
DYS XSD20A ESC Solder Version (Original)
- Model: XSD20A Solder version
- Processor: Silabs EFM8BB21
- Battery: 12.6-16.8V (3-4S Lipo)
- Current Rating: 20Amp
- BEC: No (OPTO)
- Signal frequency: 20-500Hz
- Firmware: BLHeli_S (bootloader and firmware)
- Supports: 1-2ms signal, Dshot600/Dshot300
- BLHeli_S does Damped Light only
SKU: n/a -
ESC-Drone Speed Controller
Hobbywing Skywalker- 80A UBEC
1 Output: Continuous 80A, Burst 100A up to 10 seconds.
2 Input Voltage: 3-6S Lipo, 5-18 cells NiMH.
3 BEC: 5A / 5V Switch mode BEC.
4 Refresh rate of the throttle signal: 50Hz to 432Hz.
5 Max Speed: 210000rpm for 2 Poles BLM, 70000rpm for 6 poles BLM, 35000rpm for 12 poles BLM.
(BLM = BrushLess Motor)SKU: n/a -
ESC-Drone Speed Controller
One Shot BLHeli_32 35A 32 bit 2-5S ESC
- Input: 2-5S input Maximum input 6S (close brake)
- 32bit architecture
- Telemetry capability (voltage, current, temperature, speed)
- All inputs and outputs are protected against overvoltage (~30V) and under voltage (~-30V). 3,3 and 5V capable
- Supports all common Dshot commands like Turtle Mode, 3D mode and change of rotation
- Overcurrent protection (measures the current and reduces it to max. 40A)
SKU: n/a -
ESC-Drone Speed Controller
Hobbywing Skywalker-60A- UBEC
1 Output: Continuous 60A, Burst 80A up to 10 seconds.
2 Input Voltage: 3-6S Lipo, 5-18 cells NiMH.
3 BEC: 5A / 5V Switch mode BEC.
4 Refresh rate of the throttle signal: 50Hz to 432Hz.
5 Max Speed: 210000rpm for 2 Poles BLM, 70000rpm for 6 poles BLM, 35000rpm for 12 poles BLM.
(BLM = BrushLess Motor)
6 Size: 77mm*35mm*14mm.
7 Weight: 63gSKU: n/a -
-
-
Hobbywing Skywalker-40A
Poly Bluetooth Controlled Omni Wheel Robot Kit
X2 ELF 88MM Micro brushless racing kit
HSKRC 3 Inch 140mm Carbon Fiber Racing Kit
ARF Quadcopter Upgraded Combo Kit
ACEBOTT Solar Energy Expansion Pack for QD001
Ready to Sky Plastic Landing Gear for Quadcopter
ACEBOTT QD020 ESP8266 Quadruped Bionic Spider Robot kit with Arduino IDE/ACECode(Scratch) 























