GPS Modules
Showing all 23 results
-
-
-
-
GPS Modules
GPS NEO-6M Satellite Positioning Module Development Board for Arduino STM32 51
- Product: GPS NEO-6M Satellite Positioning Module Development Board for Arduino STM32 51
- 5Hz position update rate
- Operating temperature range: -40 TO 85°CUART TTL socket
- EEPROM to save configuration settings
- Rechargeable battery for Backup
SKU: n/a -
-
-
-
Drone Parts, GPS Modules
FPV NEO-M8N GPS amp Compass Support DJI Naza M V1 & V2 Lite Flight Controller
-8%
Drone Parts, GPS ModulesFPV NEO-M8N GPS amp Compass Support DJI Naza M V1 & V2 Lite Flight Controller
- Receiver type 72-channel M8 engine.
- Sensitivity Tracking & Nav: –167 dBm.
- Oscillator TCXO (NEO-M8N/Q).
- RTC crystal Built-In.
- Lowest noise figure (NEO-M8N/Q).
- Anti-jamming Active CW detection and removal. Extra.
- Onboard SAW bandpass filter (NEO-M8N/Q).
- Memory ROM (NEO-M8M/Q) or Flash (NEO-M8N).
- Supported antennas Active and passive.
SKU: n/a -
Drone Parts, GPS Modules
25x25x8mm 28db High Gain 5cm Length Built-in Ceramic Active GPS Antenna for NEO-6M NEO-7M NEO-8M
-8%
Drone Parts, GPS Modules25x25x8mm 28db High Gain 5cm Length Built-in Ceramic Active GPS Antenna for NEO-6M NEO-7M NEO-8M
- Product: ceramic antenna cable
- Frequency: 1575.42MHz ± 4 MHz
- Antenna gain: 28dB
- Operating temperature: -45 ~ +85
- Polarization: right-hand circular polarization
- Interference suppression: 30dB ± 100MHz
- Weight: 15g
SKU: n/a -
Drone Parts, GPS Modules
GPS/GLONASS GNSS Antenna for Raspberry Pi HAT and Arduino Shield with 3 Meter Cable
-5%
Drone Parts, GPS ModulesGPS/GLONASS GNSS Antenna for Raspberry Pi HAT and Arduino Shield with 3 Meter Cable
- This GPS/GLONASS GNSS Antenna is designed for applications which require high positioning accuracy by combining signals from GPS, GLONASS, systems.
- The tiny size of this antenna allows it to be used in very space restricted environments.
SKU: n/a -
Drone Parts, GPS Modules
NEO-M8N (Ready To SKY) GPS Module with Compass for APM with extra connector for Pixhawk
-4%
Drone Parts, GPS ModulesNEO-M8N (Ready To SKY) GPS Module with Compass for APM with extra connector for Pixhawk
- Dimensions: Outer diameter 54mm
- Ready to Connect to All APM FC with 5-pin connector Attached
- Receiver type 72-channel M8 engine
- Galileo-ready E1B/C (NEO-M8N)
- Nav. update rate1 Single GNSS: up to 18 HZ
- Position accuracy 22.0 m CEP
- Acquisition2 Cold starts: 26 s
- Weight: 33gm
- Sensitivity2 Tracking & Navigation: –167 dBm
- Onboard Compass
SKU: n/a -
Drone Parts, GPS Modules
NEO-M8N GPS Module with Ceramic Active Antenna
- Antenna Size : approx. 26 x 26 x 9 (LxWxH) mm.
- Module Size : approx. 26 x 36 x 4 (LxWxH) mm.
- Net weight : approx. 16 gm.
- Gross weight : approx. 17 gm.
- Mounting : approx. 3 mm.
- The default baud rate : 9600.
- Flash memory: 64KB.
SKU: n/a -
Drone Parts, GPS Modules
NEO-M8N GPS with Compass for Pixhawk with extra connector for APM
- Ready to Connect to PIXHAWK FC with 6-pin connector Attached
- Receiver type 72-channel M8 engine
- Galileo-ready E1B/C (NEO-M8N)
- Nav. update rate1 Single GNSS: up to 18 HZ
- Acquisition Cold starts: 26 s
- Onboard Compass
SKU: n/a -
-
Drone Parts, GPS Modules
NEO-6M GPS Module with EPROM
- 5Hz position update rate.
- The cold start time of 38 s and Hot start time of 1 s.
- Configurable from 4800 Baud to 115200 Baud rates. (default 9600).
- SuperSense ® Indoor GPS: -162 dBm tracking sensitivity.
- Support SBAS (WAAS, EGNOS, MSAS, GAGAN).
- Separated 18 x 18mm GPS antenna.
SKU: n/a
