The 433MHz 100mW Radio Telemetry V2 Kit is built on the 3DR Telemetry kit, ensuring 100% compatibility with the same onboard firmware. Utilizing the open-source firmware by 3D Robotics, Unmanned Tech adapts it for their version. Compatible with Ardupilot or Pixhawk-based systems, this kit establishes a two-way telemetry connection between your drone and ground station. The V2 version features interchangeable air and ground modules, each equipped with a USB connector and DF13 connector. Full support and warranty are provided, affirming the reliability and functionality of this product. For Pixhawk connection, it’s recommended to purchase a 6-pos to 6-pos cable for optimal performance.
Drone, FPV Antennas and Trans-Receivers
433Mhz 100mW Radio Telemetry Kit
Availability:
Available on backorder
- Available in 433Mhz
- Air data rates up to 250kbps
- The range is approx 1 mile (1.6 Km)
- MAVLink protocol framing and status reporting
- Frequency hopping spread spectrum (FHSS)
- Adaptive time division multiplexing (TDM)
- Support for LBT and AFA
- Micro-USB port
- Adaptive flow control when used with APM
- Based on the HopeRF HM-TRP radio module, featuring a SiLabs Si1000 RF microcontroller.
₹7,325.00 ₹8,325.00
Available on backorder
1 x 3DR Radio Telemetry with the case and Tx and Rx Antenna.
2 x cables (APM/PIX).
2 x 3.5dbi antennas.
Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
HSKRC 3 Inch 140mm Carbon Fiber Racing Kit
Due AT91SAM3X8E ARM Cortex-M3 Board with Micro USB Cable Compatible with Arduino
Creality -Hotend Kit Ender3 V2
ARF Quadcopter Economy Combo Kit
F450 F550 / Q450 Q550 Replacement Arm Red (220mm) – Made in INDIA
Official Raspberry Pi 16mm Telephoto Lens for Pi High Quality Camera
Pixhawk 2.4.7 Upgraded Flight Controller kit with GPS Module Combo Kit
Robocat 270 Racing Quadcopter Frame
Mini TS5828 FPV Set 5.8G 32CH 600mW AV RC Transmitter
Uno R3 Board without Cable 







There are no reviews yet.