ACEBOTT QC027 Micro:bit Handle Kit Wireless Controller (without Micro:bit) Subtotal: ₹1,755.00
-14%
Official Arduino Boards
Official Arduino MKR Mem Shield ASX00008
Availability:
Out of stock
- Interface: SPI
- SPI Flash Memory: 2 MB
- Circuit Operating Voltage: 3.3 V
₹2,522.00 ₹2,923.00
Out of stock
The Arduino MKR MEM shield will allow you to add more flash memory and storage. It provides 2 megabytes of flash memory. It also includes a slot for adding a microSD card to store several gigabytes of storage. This can allow you to store data for later analysis.
Package Includes:
1 x Arduino MKR Mem Shield ASX00008
Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
Related products
-
Development Boards
Nano R3 W/O USB Cable Compatible with Arduino (Un Soldered)
- Operating Voltage (logic level): 5V
- 8 analog inputs ports: A0 ~ A7
- 14 Digital input / output ports: TX, RX, D2 ~ D13
- 1 pair of TTL level serial transceiver ports RX / TX
- Using Atmel Atmega328P-AU MCU
- There is a bootloader installed in it
- Standard 0.1” spacing DIP (breadboard friendly).
- Manual reset switch.
SKU: n/a -
-
Arduino Single Boards Computer
ESPLORA Joystick Photosensitive Sensor Board, Support LCD Compatible with Arduino
-10%
Arduino Single Boards ComputerESPLORA Joystick Photosensitive Sensor Board, Support LCD Compatible with Arduino
The design of the Esplora board recalls traditional gamepad design with the analog joystick on the left and four push buttons on the right. The Esplora has the following onboard inputs and outputs :
- Analogue joystick with central push-button two axis (X and Y) and a centre pushbutton.
- 4 push-buttons laid out in a diamond pattern.
- Linear potentiometer slider near the bottom of the board.
- Microphone for getting the loudness (amplitude) of the surrounding environment.
- Light sensor for getting the ambient brightness.
- Temperature sensor reads the ambient temperature (please note that the temperature sensor is not fitted, however we do stock this component).
- Three-axis accelerometer measures the board’s relation to gravity on three axes (X, Y, and Z)
- Buzzer can produce square-waves.
- RGB led bright LED with Red Green and Blue elements for colour mixing.
- 2 TinkerKit Inputs to connect the TinkerKit sensor modules with the 3-pin connectors.
- 2 TinkerKit Outputs to connect the TinkerKit actuator modules with the 3-pin connectors.
- TFT display connector connector for an optional color LCD screen, SD card, or other devices that use the SPI protocol.
- In order to utilise the total number of available sensors, the board uses an analogue multiplexer. This means a single analog input of the microcontroller is shared among all the input channels (except the 3-axis accelerometer). Four additional microcontroller pins choose which channel to read.
SKU: n/a
There are no reviews yet.