Brushless 40A 2-4S ESC is specifically made for quadcopters and multi-rotors. Which provides faster and better motor speed control giving better flight performance compared to other available ESCs.
Brushless 40A 2-4S ESC for Drone comes with a multi-integrated special program, fast throttle response, and surpasses all kinds of open-source software. Firmware was optimized specifically integrated circuitously for the disc motor, and it has very good compatibility this ESC is compatible with 2-4s Lipo Battery.
The throttle signal line is twisted wire to reduce crosstalk within the transmission signal generated by the copper, so that more stable flight. This ESC Supports refresh rates of up to 621Hz throttle signal, is compatible with various flight controllers. (Note: the throttle signal over 500Hz are all non-standard throttle signals)
Due to ultra-low resistance MOSFET, it has a strong flow capacity. With MOSFET’s special driver integrated circuit, its performance and stability far surpass the driving circuit with discrete components built. This ESC is not able to flash the firmware
Application:
- BLDC Motors
- Multirotors
- Rc Planes etc.
Package Includes:
1 x Brushless 40A 2-4S ESC
Raspberry PI POE+ Hat for 3B+ and Pi 4
Raspberry Pi Camera Module 3
ODYSSEY – STM32MP157C Raspberry Pi 40-Pin Compatible with SoM
ACEBOTT - QD109 Battle Arena Kit For Battle Car
reComputer J4012-Edge Al Device with Jetson Orin™™ NX 16GB module, 4xUSB 3.2, Μ.2 Key E & Key M Slot, Aluminum case, Pre-installed JetPack System on 128GB NVMe SSD (Without Adapter)
Argon Fan HAT for Raspberry Pi 4, 3B,3 B+, Includes 40mm Fan
1/4 Cmos 640X480 USB Camera with Collapsible Cable for Raspberry Pi
Readytosky 80A ESC 2-6S Brushless ESC Speed Controller for RC Drone
Waveshare CAN bus Module (B) for Raspberry Pi Pico, enabling long range communication through SPI
Pixhawk 2.4.7 Upgraded Flight Controller kit with GPS Module Combo Kit
Waveshare ESP32-S3 Mini Development Board, Based on ESP32-S3FH4R2 Dual-Core Processor, 240MHz Running Frequency, 2.4GHz Wi-Fi & Bluetooth 5
Official Micro-HDMI (Male) to Standard HDMI (Male) Cable for Raspberry Pi
A205E Mini PC, With Jetson Xavier NX 8GB Module
Nano Board R3 with CH340 Chip without USB Cable Compatible with Arduino (Unsoldered) 








There are no reviews yet.