FPV NEO-M8N GPS amp Compass Support DJI Naza M V1 & V2 Lite Flight Controller
- Receiver type 72-channel M8 engine.
- Sensitivity Tracking & Nav: –167 dBm.
- Oscillator TCXO (NEO-M8N/Q).
- RTC crystal Built-In.
- Lowest noise figure (NEO-M8N/Q).
- Anti-jamming Active CW detection and removal. Extra.
- Onboard SAW bandpass filter (NEO-M8N/Q).
- Memory ROM (NEO-M8M/Q) or Flash (NEO-M8N).
- Supported antennas Active and passive.
₹2,219.00 ₹2,399.00
Supports DJI Naza M V1 & V2 Lite Flight Controllers with FPV NEO-M8N GPS amp Compass. The NEO-M8N is a new generation GPS device that boasts low power consumption and high precision. Its ultimate accuracy is 0.6 meters, or about 0.9 meters, which is greater than the 1.4-1.6 meters accuracy of the NEO-7N, the previous generation device. It also supports more protocols, including GPS/QZSS L1 C/A, GLONASS L10F, BeiDou B1 protocol, and mode.
32-bit processing, significantly better than an 8-bit CPU, is compatible with the NAZA M V1 & V2 flight controller. Please pay attention to the GPS’s arrow, which represents a flyer’s head. Comparable GPS calibration and application. includes a 30-cm soft silicone gel cable. A surface was covered with black rubber to make it softer. To lessen signal interference from other electrical devices, a metal foil label has been placed on the bottom of the GPS (Notice: black cable= GND, white cable= TX, yellow cable= RX, red cable= 5V, 3.3-7.5V is OK).
Specification:
| Model | FPV Ublox NEO-M8N |
|---|---|
| Receiver Type | 72-channel Ublox M8 engine. |
| Main Chip | Ublox NEO-M8N |
| Sensitivity (dBm) | –148, –156 |
| Position Accuracy (Meter) | 2, 2.5 |
| Acceleration (g) | <4 |
| Navigation Update Rate | up to 18 HZ. |
| Operating Temperature Range (°C): | -24 to 84 |
| Input Interface | 36219, 36218, 36216, 36217 |
| Tracking Sensitivity (dBm) | –167 dBm. |
| Co-Ordinate System | WGS-84 |
| Capture Time | 0.1s Average |
| Boot Time | 1S |
| Dimensions (mm) LxWxH | (dia x width), 54 x 15.2 |
| Weight (gm) | 28 |
| Cable Length (cm) | 30 |
| Input Supply Voltage (VDC) | 1.4 ~ 3.6 |
| Shipping Weight | 0.135 kg |
| Shipping Dimensions | 7 × 4 × 1 cm |
Feature:
- Assistance AssistNow GNSS Online.
- AssistNow GNSS Offline (up to 35 days)3.
- AssistNow Autonomous (up to 6 days).
- OMA SUPL & 3GPP compliant.
- Oscillator TCXO (NEO-M8N/Q).
- Crystal (NEO-M8M).
- RTC crystal Built-In.
- Noise figure On-chip LNA (NEO-M8M). Extra LNA for.
- Lowest noise figure (NEO-M8N/Q).
- Anti-jamming Active CW detection and removal. Extra.
- Onboard SAW bandpass filter (NEO-M8N/Q).
- Memory ROM (NEO-M8M/Q) or Flash (NEO-M8N).
- Supported antennas Active and passive.
- Odometer Travelled distance.
- Data-logger For position, velocity, and time (NEO-M8N).
- RoHS compliant (lead-free).
- Manufactured and fully tested in ISO/TS 16949 certified production sites.
- Uses M8 chips qualified according to AEC-Q100.
- Supply voltage 1.65 V to 3.6 V (NEO-M8M).
- Power consumption4 23 mA @ 3.0 V (continuous).
- 5 mA @ 3.0 V Power Save Mode.
- (1 Hz, GPS mode only).
- NEO-M8N-0 M8 Concurrent GNSS LCC Module.
- TCXO, flash, SAW, LNA.
- Time pulse Configurable 0.25 Hz to 10 MHz.
- Using 32-bit processor, compatible with DJI NAZA LITE V1 & V2 flight controller, incomparably superior to the 8-bit processor.
- Please take notice of the arrow on GPS, which stands for the head of the flyer.
- Similar calibration and usage with DJI GPS.
- Coming with soft silicone gel cable 30cm.
- For softness, black rubber was wrapped on the surface.
- (Notice: black cable= GND, white cable=TX, yellow cable=RX, red cable=5V, 3.3-7.5V is ok).
- Metal foil label has been mounted on the bottom of GPS to reduce signal interference from other electronic equipment.
There are no reviews yet.