Available on backorder
₹3,869.00 ₹4,869.00
Available on backorder
Holybro RemoteID Module is a low-cost, small-size, and lightweight module that broadcasts information about UAVs in flight through WiFi and Bluetooth. It supports both CAN and serial protocols. It is an FCC and CE-approved radio module. The products run open-source firmware (ArduRemoteID) and provide a so-called standard Remote ID solution, primarily targeting drone manufacturers & system integrators.
1x Remote ID
1x Antenna
1x JST GH 6pin 150mm Cable
1x JST GH 4pin 150mm Cable
Only logged in customers who have purchased this product may leave a review.
1. Connectivity: The set links your flight controller to a computer, laptop, or tablet via USB or UART.
2. V2 Radios: No separate Air/Ground module needed; supports both UART and USB connections.
3. Live Data: Displays GPS position, system voltage, heading, etc., in real-time.
4. Joystick Control: Allows aircraft control via a computer using open-source MAVLink-based ground station software.
6. Affordability: Budget-friendly kit with longer range and superior performance.
7. Frequency Band: Operates on the 915MHz band.
8. Full-Duplex Link: Utilizes Hoper’s HM-TRP modules with custom open-source firmware.
reComputer J101 Dev Kit Carrier Board for Jetson Nano, With micro SD card slot 
5.8G 3dBi FPV TX RX Antenna Pair (SMA-Male Plug) 
There are no reviews yet.