NEO-M8N GPS with Compass for Pixhawk with extra connector for APM
- Ready to Connect to PIXHAWK FC with 6-pin connector Attached
- Receiver type 72-channel M8 engine
- Galileo-ready E1B/C (NEO-M8N)
- Nav. update rate1 Single GNSS: up to 18 HZ
- Acquisition Cold starts: 26 s
- Onboard Compass
₹2,399.00 ₹2,699.00
With its onboard compass, low power consumption, and high precision, the new generation NEO-M8N High Precision GPS Module for PIXHAWK and APM FC is ready to connect to PIXHAWK FC. Its accuracy is 0.6 meters, or nearly 0.9 meters, which is greater than that of the previous generation NEO-7N, which had an accuracy of 1.4–1.6 meters. It also supports GPS/QZSS L1 C/A, GLONASS L10F, BeiDou B1 protocol, and more.
Additionally, by simply swapping out the additional 5-pin connector included in the package, you may connect the same module to the APM Flight Controller. So if you want GPS telemetry for your FPV flying or camera ship? This new generation GPS NEO-M8N is the answer. Capable of accuracy between 0.6 and 0.9 meters it is a significant improvement over previous models. Sattelite searching and acquisition is very fast, generally taking around ten seconds to locate and acquire up to 6 satellites. It also has a built-in compass with a 10Ghz refresh rate and a low noise figure which ensures this GPS module offers excellent performance.
Connector difference of PIXHAWK and APM FC:
Note: This Module comes with 6 pin connectors connected by default (i.e. Ready to connect to PIXHAWK FC) and extra 5 pin connectors for APM FC for Swapping.
Specification:
| Model | Ublox NEO-M8N |
|---|---|
| Receiver Type | 72-channel Ublox M8 engine. |
| Main Chip | Ublox NEO-M8N |
| Input Supply Voltage (VDC) | 0.5 ~ 3.6 |
| Sensitivity (dBm) | Tracking & Navigation: -161 dBm |
| Position Accuracy (Meter) | 2, 2.5 |
| Acceleration (g) | <4 |
| Navigation Update Rate | up to 18 HZ. |
| Operating Temperature Range (°C): | -45 to 105 |
| Tracking Sensitivity (dBm) | -161 dBm |
| Co-Ordinate System | WGS-84 |
| Capture Time | 0.1s Average |
| Avg Cold Start Time (s) | 30 |
| Warm Start Time (s) | 1 |
| Boot Time | 1S |
| Maximum Altitude (m) | 18000 |
| Dimensions (mm) LxWxH | 54 x 22 (Dia x W) |
| Weight (gm) | 23 |
| Cable Length (cm) | 20 |
| Shipping Weight | 0.06 kg |
| Shipping Dimensions | 7 × 6 × 6 cm |
Features:
- GPS/QZSS L1 C/A, GLONASS L10F, BeiDou B1
- SBAS L1 C/A: WAAS, EGNOS, MSAS
- Galileo-ready E1B/C (NEO-M8N)
- Onboard Compass
- Assistance AssistNow GNSS Online
- AssistNow GNSS Offline (up to 35 days)
- AssistNow Autonomous (up to 6 days)
- OMA SUPL & 3GPP compliant
- Oscillator TCXO (NEO-M8N/Q),
- Crystal (NEO-M8M)
- RTC crystal Built-In
- Noise figure On-chip LNA (NEO-M8M). Extra LNA for
- lowest noise figure (NEO-M8N/Q)
- Anti-jamming Active CW detection and removal. Extra
- onboard SAW bandpass filter (NEO-M8N/Q)
- Memory ROM (NEO-M8M/Q) or Flash (NEO-M8N)
- Supported antennas Active and passive
- Odometer Travelled distance
- Data-logger For position, velocity, and time (NEO-M8N)
Package Includes:
1 x NEO M8N GPS for Pixhawk and APM flight controller
1 x Extra 5-pin Connector for APM FC
Note: This is a product of ReadyToSky brand powered by Ublox chip inside
Based on 0 reviews
Be the first to review “NEO-M8N GPS with Compass for Pixhawk with extra connector for APM”
Related products
-
-
Drone Kit, Drone Parts
Pixhawk 2.4.8 Basic Flight Controller kit with GPS Module
- 1 x Pixhawk V2.4.8 Flight board with Original Shell.
- 1 x 16GB TF card(IO firmware has written).
- 3 x Connecting Cables.
- 1 x Buzzer Module.
- 1 x Pixhawk PPM Encoder Module.
- 1x JR plug 10P input end of the cable 100mm.
- 1 x JR plug 4P output end of the cable 100mm.
- 1 x Glass Fiber Flight Controller Anti-vibration/Shock absorber Set.
- 1x NEO-M8N GPS Module with translucent Shell.
- 2 x cables (APM/PIX).
- 1 x GPS Folding Base Antenna set.
- 1 x APM 2.5.2/2.6/2.8 Pixhawk Power Module.
- 2 x 3.5dbi antennas.
- 1 x 3DR Radio Telemetry with the case(Tx and Rx).
SKU: n/a
There are no reviews yet.