This is a One Shot BLHeli_32 35A 32-bit 2-5S ESC.
BLHeli is firmware designed for multi-copter performance that runs on some Atmel and SiLabs ESCs and supports OneShot125. BLHeli Suite is the companion application (Windows only) that allows users to flash and configure BLHeli ESCs (Electronic Speed Controllers).
The 32-bit architecture enables the ESC to run at incredible speeds, resulting in better performance, faster input signals, and lower latency compared to older 8-bit ESCs. These ESCs are low profile and compact, saving weight and making builds easy. OneShot125 is a special mode for ESCs running BLHeli firmware, allowing the supported flight controller to communicate very quickly with the ESC, enabling motors to react much faster than standard PWM communication protocols.
It adopts a 32-bit STM32F051 main control chip, which offers faster response speed and processing capability. The operating frequency of up to 48MHz and high-performance three-in-one drive reduce throttle signal receiving delay, enhancing the response and control of the motor. High speed and precision allow pilots to enjoy the thrill and advantage of flying at speed.
BLHeli was the original open-source software but is no longer maintained and is not available on modern ESCs. BLHeli_32 is closed-source and based on 32-bit ARM MCUs. All modern ESCs use BLHeli_32, which remains open-source firmware.
Packages Includes:
1 x BLHeli_32 35A 32 bit 2-5S ESC
F450 F550 / Q450 Q550 Replacement Arm Red (220mm) – Made in INDIA
X2 ELF 88MM Micro brushless racing kit
Raspberry Pi 4 Model-B with 4 GB RAM
Foxeer DalProp Cyclone Triblade T5139.5 Propeller 2 Pair CW+CCW-Metal Grey
Slamtec RPLiDAR A2M12 360 Degree Laser Scanner Kit – 12M Range
APM 2.8 Upgraded Flight Controller kit with GPS Module Combo Kit
F450 / Q450 Quadcopter Frame(PCB Version with Integrated PCB) + Plastic Landing Gear Combo Kit – Made in INDIA
5MP Raspberry Pi 3/4 Model B Camera Module Rev 1.3 with Cable
WEMOS ESP8266 D1 Pro mini-16 m External Antenna Connector
Pixhawk 2.4.8 Basic Flight Controller kit with GPS Module
ARF Quadcopter Economy Combo Kit
APM 2.8 Basic Flight Controller kit with GPS Module Combo Kit
RepRap MK2B 3D printers Dual Power PCB Heat Bed With 18AWG Cable
ESC Power Distribution Board Soldered XT60 Plug & 3.5mm Banana Bullet Connectors For 250mm Multicopter FPV 





There are no reviews yet.