SmartElex GSM/GPRS Shield for Arduino

Using the SmartElex GSM/GPRS Shield for Arduino, you may link your board to a mobile GSM network! It connects straight to your Arduino and lets you use GPRS to access the internet, make and receive calls, and send and receive SMS.

Everything you need to complete your Arduino-based GSM project is included in the SmartElex GSM/GPRS Shield, including the GSM/GPRS Module, SIM Card Holder, Cellular Antenna, Headphone Connector, Bluetooth 3.0 with Antenna, and more. It makes your GSM project a lot easier to understand and lets you use the Arduino to start your GSM project quickly.

The Quectel M66 Module is utilized by the SmartElex GSM/GPRS Shield. The shield is configured and communicated with via AT commands.
Through a serial interface, the shield and you can communicate with each other. You may use your Arduino’s software serial port thanks to the shield.

Important:  This Shield can operate with supply range between 6.5V to 30V. But as VIN pin of this shield (i.e.+ pin) will directly get connected to VIN pin of your Arduino board (while using with Arduino boards).

So, if you use this GSM shield with Arduino Uno or Mega then use supply Voltage between 6.5V to 12V only otherwise due to Higher voltage your Arduino board regulator will burnout. Also do not use Arduino’s 12V input and shield’s 6.5V to 30V supply simultaneously.

Recommended Voltage for Individual shield: 6.5V to 30V   
Recommended Voltage with Arduino:  6.5V to 12V 

Features:

1. Quad-band GSM/GRPS 850/EGSM 900/DCS 1800/PCS 1900 MHz
2. Make/Receive voice calls with 3.5 mm Headphone  Jack
3. Supports Sending/Receiving of SMS messages
4. Based on the M66 module from Quectel.
5. Include onboard Bluetooth 3.0 with Antenna
6. Both 5V and 3.3V voltage level for RX and TX.
   

   ---

   Package Includes:

   1 x SmartElex GSM/GPRS shield for Arduino

   1 x GSM/GPRS Detachable Antenna

   1 x User Manual