W5100 Ethernet Module Ethernet Network Module for arduino

Introducing the W5100 Ethernet Module, specifically designed for Arduino projects. This module boasts a full-featured, single-chip Ethernet controller tailored for embedded applications, prioritizing ease of integration, stability, performance, and cost-effectiveness.

The W5100 Ethernet Module streamlines Internet connectivity implementation without the need for an operating system. It complies with IEEE 802.3 10BASE-T and 802.3u 100BASE-TX standards, ensuring compatibility with various networking environments.

Equipped with a fully hardwired TCP/IP stack and integrated Ethernet MAC & PHY, the W5100 module supports essential protocols including TCP, UDP, IPv4, ICMP, ARP, IGMP, and PPPoE. Its 16-kilobyte internal buffer facilitates efficient data transmission.

With the W5100 Ethernet Module, Ethernet controller management is simplified, requiring only straightforward socket programming for seamless integration into your projects.

Pin Connection

Connect to Uno/Mega
V+5: 5v
GND: GND
MO: D11 (D51)
MI: D12 (D50)
SCK: D13 (D52)
RST: RESET

Features:

1. Support Hardwired TCP/IP Protocols: TCP, UDP, ICMP, IPv4 ARP, IGMP, PPPoE, Ethernet
2. 10BaseT/100BaseTX Ethernet PHY embedded
3. Auto-Negotiation (Full-duplex and half duplex)
4. Support Auto MDI/MDIX
5. Simultaneously Supports to 4 independent sockets
6. Not support to IP Fragmentation
7. Internal 16Kbytes Memory for Tx/Rx Buffers
8. 0.18 µm CMOS technology
9. 3.3V operation with 5V I/O signal tolerance
10. Provide Serial Peripheral Interface (SPI MODE 0, 3) support
11. Support ADSL connection (with support PPPoE Protocol with PAP/CHAP Authentication mode)

Package Includes:

1 x W5100 Ethernet Module.